Walrus Audio Melee Wall of Noise - tgt11 - tgt11
Hem » Pedaler » Reverb pedal » Produkt

Walrus Audio Melee Wall of Noise

4095 :-
Lagerstatus: I lager
FRI FRAKT FRI FRAKT PÅ DENNA PRODUKT
SNABB SERVICE
Vi skickar samma dag om ordern är lagd innan kl 12:00 CET

14 DAGAR FULL RETURRÄTT
Byt eller pengarna tillbaka

We give you the two most quintessential effects that yield unruly amounts of power and influence to an
instrumentalist: reverb and distortion.

They have been harnessed and woven together for an eternity of
ethereal power with The Melee: Wall of Noise. The Melee unapologetically uses a joystick to meld reverb
and distortion into one massive blaze of sound. With the flip of the order switch, run the distortion into the
reverb or reverb into distortion; signal chain is your call now. For the explorer, the Melee can run one of
three different reverb programs Ambient, Octave, and Reverse.
In a less is more approach, we’ve intentionally decided on controls that are fun to use and will inspire a
wealth of creative output. Use the joystick to control the amount of distortion by moving it up and down.
Moving the joystick left and right will adjust your reverb mix. The tone and decay toggles have low, medium,
and high settings. Modulation can be added to the wet signal by holding down the bypass switch and
moving the decay toggle. The left position is no modulation, the middle is a slight modulation, and the right
is a high modulation.

ALGORITHMS

The Melee is equipped with three different reverb programs, which can be changed by simultaneously
pressing the bypass and sustain stomp switches. Experiment with the order toggle switch to hear how
differently these all react in front and after the distortion!
• Ambient Reverb (Pink LED) - Huge reverb capable of massive trails and engulfing your chords into an
angry wash of sound. Great for soaring melodic lines or shoegaze-driven chord progressions.
• Octave Down Reverb (Yellow LED) - Similar to the Dark mode in the Slö, you’ll find an eerie lower octave
hovering in the reverb trail for a nice and dark atmospheric touch.
• Reverse Reverb with Feedback (Blue LED) - Add reversed reverb trails back into your signal, create
gentle melodies or push into reverse feedback overload. Big, slow, and sad chords love to hang out
here.


MOMENTARY

Press and hold the sustain switch to ramp up the reverb trails. Release and the trails will ramp back down to
where the decay switch is currently set. The sustain switch can also latch in all three programs. Press and
release the Sustain switch to capture and sustain the current reverb decay for long pad-like sounds in your
wet mix. Press again to release the latch, and the reverb trail will taper off based on the position of the
decay knob.


SPECS

• The Melee comes coated in a glossy neon pink enclosure with white, yellow, and green inks with art by
David Hüttner.
• The die-cast enclosure’s exact size is 3.62” x 4.79” x 3.14” (including joystick height).
• Three bypass modes, DSP, DSP+True, True Bypass
• Power requirements are 9VDC, center negative (200mA minimum).
• The use of an isolated power supply is recommended for powering all Walrus Audio Pedals.
• Daisy chain power supplies are not recommended.
• Power supply not included.

 

Läs mer







We've selected shipping to

SVERIGE

[Change country below]