Victory V4 The Copper Preamp Pedal - tgt11
Hem » Pedaler » NYHETER » Produkt

Victory V4 The Copper Preamp Pedal

4295 :-
Lagerstatus: Förboka välj faktura (går att avboka innan vi levererar)
FRI FRAKT FRI FRAKT PÅ DENNA PRODUKT
SNABB SERVICE vi skickar samma dag om ordern är lagd innan kl 13:00 CET
14 DAGAR FULL RETURRÄTT byt eller pengarna tillbaka

Based on 2019’s Copper amplifier, this preamp pedal is designed to sound like the chime and rock of the late-1950’s British amplifiers.

Chiming EL84 cleans, expressive mid-gain sweetness and rich classic rock roar are packed into this pedal, for exceptional all-valve overdrive.
As with the rest of the V4 Preamp pedal range the V4 Copper can be used straight into the front of your amp or recording interface, or alternatively use it in conjunction with your amp’s FX loop to bypass the front end of your existing amp for a whole new sound experience.
The V4 Copper comes with the same powerful three-band EQ that is found across the range but this is where the similarities stop. In a first for the V4 series, the Copper has a treble boost and tone control, perfect for tweaking your sound and the treble boost is footswitchable for greater control. Like the Copper amp range the V4 preamp comes with a gain control and bass cut to dial in tones from Skinny British 60’s pop jangle through the thick and fat boutique tones.

1. TREBLE BOOST
Designed to be like a gain boost, this treble boost 3 circuit helps to push the V4’s front end to create
creamy valve overdrive and sustain. Bypass (on/
off) is switchable remotely too.

2. BASS CUT SWITCH
Perfect for tightening your sound, there are three positions, designed as a global setting to best match the V4 Pedal Preamp to your amp.

3. TWO INDEPENDENT VOLUMES
Set the output levels of each mode independently, to taste. SET TO ZERO BEFORE TURNING ON!

4. THREE-BAND EQ
Powerful bass, middle and treble controls.These also have a significant effect on the gain character and drive levels – just like in any valve guitar amp.

5. PROTECTIVE RAIL
Protection for the knobs when you’re stomping.

6. CONNECTION JACKS
Clearly labelled so there is no confusion.

7. POWER INLET JACK
12V DC, 800mA minimum.There are four valves, so we need plenty of current! Adapter supplied.

Läs mer


We've selected shipping to

SVERIGE

[Change country below]